Pinout & LED Patterns
Two connector groups are available at the board edge.
Power and USB connector
Section titled “Power and USB connector”| Pin | Signal | Type | Description |
|---|---|---|---|
| 1 | 5V |
Power In | 5 V supply input. Powers the controller when not using USB bus power |
| 2 | USB+ |
USB D+ | USB data positive |
| 3 | USB− |
USB D− | USB data negative |
| 4 | GND |
Ground | Common ground reference |
Serial / RC connector
Section titled “Serial / RC connector”| Pin | Signal | Type | Description |
|---|---|---|---|
| 1 | UART_RX |
Digital In | UART receive (3.3 V logic level) |
| 2 | UART_TX |
Digital Out | UART transmit (3.3 V logic level) |
| 3 | GND |
Ground | Serial ground reference |
| 4 | GND |
Ground | Additional ground |
LED indicators
Section titled “LED indicators”An on-board LED on each of the left-hand and right-hand boards indicates power.

